Do any of you guys know the EXACT specs for the zerk fittings in an EMPI ball joint beam? I have it now mounted to the chassis, so I can't haul it to the local parts store....
thanks dudes!
zerky zerky zerky
Moderator: Ken
3 posts
• Page 1 of 1
zerky zerky zerky
by carlos del carpio » 12 Sat Nov, 2005 6:17 pm
Got your attention?
Do any of you guys know the EXACT specs for the zerk fittings in an EMPI ball joint beam? I have it now mounted to the chassis, so I can't haul it to the local parts store....
thanks dudes!
Do any of you guys know the EXACT specs for the zerk fittings in an EMPI ball joint beam? I have it now mounted to the chassis, so I can't haul it to the local parts store....
thanks dudes!
you must have pride....in your ride....
-
carlos del carpio - Buggyholic
- Posts: 378
- Joined: 14 Fri Oct, 2005 6:20 pm
- Location: South Texas...waaaay south!
by blackthree4me » 16 Wed Nov, 2005 7:50 pm
its either of the 2 a 6 mm or 8mm not sure on the specific brand of your
beam though
mine came with a 7mm imagine that I have not been able to find any yet
I gotta get on that soon
blackthree4me
beam though
mine came with a 7mm imagine that I have not been able to find any yet
I gotta get on that soon
blackthree4me
if it aint broke, break it then fix it
-
blackthree4me - Buggyholic
- Posts: 631
- Joined: 12 Wed Oct, 2005 1:13 pm
- Location: Spring TX
by carlos del carpio » 16 Wed Nov, 2005 9:00 pm
Thanks, as previously mentioned, it's an EMPI beam, rather new, about a year...I just gotta get some, to finish my project..YAY!
you must have pride....in your ride....
-
carlos del carpio - Buggyholic
- Posts: 378
- Joined: 14 Fri Oct, 2005 6:20 pm
- Location: South Texas...waaaay south!
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 7 guests