Texas Manx Club

A Place for "Texas Dune Buggy" nuts! 2

Skip to content

Bolt Size

Chassis & Electrical. Ask a question, share your knowledge, build it right.

Moderator: Ken

Post a reply

Bolt Size

Postby Bill K » 29 Sun Mar, 2009 7:39 pm

Does anyone know what the metric bolt size is for the bolt that attaches the bottom center of the intake manifold to the block on a 1600 engine?
Dream It - Plan It - Build It
User avatar
Bill K
Buggyholic
 
Posts: 2171
Joined: 06 Thu Oct, 2005 8:08 am
Top

Postby the 'Maniac » 02 Thu Apr, 2009 11:15 pm

It should be an 8mm X 1.25 thread pitch & it's about 50-60mm long. I've run across a few that used a "stud", but I always change them to a bolt.
Have FUN FUN FUN... the 'Maniac
the 'Maniac
Buggy Driver
 
Posts: 27
Joined: 02 Fri May, 2008 3:11 pm
Location: Ventura, CA
Top

Postby Bill K » 03 Fri Apr, 2009 10:35 am

Thanks so much.
Dream It - Plan It - Build It
User avatar
Bill K
Buggyholic
 
Posts: 2171
Joined: 06 Thu Oct, 2005 8:08 am
Top
Post a reply

Return to Technical Talk

Who is online

Users browsing this forum: No registered users and 6 guests

Powered by phpBB® Forum Software © phpBB Group
cron