Matching a AE case to early swing axle.

Chassis & Electrical. Ask a question, share your knowledge, build it right.

Moderator: Ken

Matching a AE case to early swing axle.

Postby David Head » 03 Tue Nov, 2009 12:40 pm

Is there any clearance issue putting 1600 AE case on a 1967 swing axle tranny. Assuming you have the right T. O. bearing and clutch set up. Do the splines fit and will the flywheel fit into the bell housing??
Maroon Manx

(o\_!_/o)
David Head
Buggyholic
 
Posts: 456
Joined: 22 Thu Sep, 2005 8:37 pm
Location: East Texas

Postby jspbtown » 03 Tue Nov, 2009 1:26 pm

I "think" the 1967 was the first year for the 12 volt. If so, it should have the 200mm flywheel and will bolt right up with no problems. If it was the 6 volt you just need some clearancing which is easy.

I also suggest a started from an autostick. Much better option.
jspbtown
Buggyholic
 
Posts: 250
Joined: 26 Wed Dec, 2007 9:57 am


Return to Technical Talk

Who is online

Users browsing this forum: No registered users and 7 guests